or Connect
New Posts  All Forums:Forum Nav:

Reprofiling using a CC?

post #1 of 12
Thread Starter 

I apologize if this specific topic has been covered - I spent 15 minutes searching and couldn't find this specific question.


I have an "extra" Victorinox 8" chef's in my block, and after reading a lot of posts here, I would like to try to reprofile it to a more acute angle. A friend has a Trizor Chef's Choice, and I thought reprofiling my Vic would be a no-cost/low-risk way to get a 15ish angle and work on my technique with a thinner profile.


Two questions - does this sound like a good way to start? And can anyone provide any advice on how to properly reprofile using the CC? 


I have put a Wicked Edge on my Xmas list despite the raised eyebrow of my bride, but in the meantime, getting stones or sharpeners isn't in the cards. I am hoping that the reprofiled Vic will make a believer out of her. :)


Thanks in advance,



post #2 of 12
Another final edge won't give it a thinner profile. If you want a thinner profile, you should ... thin. Start with building a relief bevel of some 10 degree. That will boost performance. If you do that, it isn't that important anymore whether the final edge is at 16 or 18 degree.
post #3 of 12
"Profile" is generally understood to mean the shape of the blade. What you're talking about is changing the angle of the bevels.

What are you trying to accomplish?
post #4 of 12
Far from me to do any authoritative statement about English usage, but I've noticed a lot of people do use "reprofiling" to indicate "changing a blade's geometry". I believe that is even quite common, if not generally accepted.
post #5 of 12
Thread Starter 
I apologize if I am using the wrong terminology- I am new to this. mhlee is right, I think. I am trying to change the angle if the bevels from 20 to 15 degrees.
post #6 of 12
The question remains, though, what are you trying to achieve? For better performance thinning is far more important than the actual cutting edge angle.
post #7 of 12
Thread Starter 
Benuser, I am trying to get my knife sharper. I have read a lot on these forums about how proper technique can't be learned without adequate sharpness. I have reasonably good knife skills, but I would like to get more efficient and precise. Does that help? I am open to any and all advice.
post #8 of 12
If you change the edge angle without prior thinning don't expect any durable result. The thickness behind the edge will cause excessive friction, and damage your steeper edge. If you're not prepared to thin behind the edge a steeper edge won't contribute to any lasting performance enhancement, IMHO.
post #9 of 12
Thread Starter 
Ok. How do I thin behind the edge?
post #10 of 12


post #11 of 12
Thread Starter 
Thanks for the video. Very informative. Should I infer from the video that the only way to thin is with a stone? And that I will get no advantage (and in fact weaken my knife) by running it through all three stages in a Chefs Choice?
post #12 of 12
There are other ways to do it… But the chefs choice is not the way
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Cooking Knife Reviews