Chef Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
618 Posts
it depends on the size - if your after something a little smaller, you could use silicon molds to save some time, but im not real sure about where to source them.

Hehe, this reminds me of a story a friend told me about a ice carving gig - he had just finished a charity gig using something rediculous like 25x6mtr by 4 mtr blocks and after, they just dumped the sculptures into the harbour. Apparently this freaked out the sydney ferries and the police came a looking for the source of these exquistely carved "ice bergs", needless to say, he wont be doing that again.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top