Chef Forum banner
1 - 1 of 15 Posts

· Premium Member
Joined
·
11,794 Posts
Stamping has nothing to do with the blade being flexible. Stamping is a cost saving method compared to some other choices. There are very good steels that take to stamping just fine. Many stamped blades are cheap steel and overly thin. That's not stampings fault. That's a poor design choice.

I think the geometry of the Victorinox is better than the Mercer.
 
1 - 1 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top